Uses and Install Instructions

SUGGESTED USES

There are a variety of uses for the “NO Glow Cap”. Here are a few suggestions:
• Between bushes, trees or gutters.
• Between windows or doors (Inside and/or Outside).
• Around the trunk of a tree, pole or railing.
• Running up or down the wall or gutter, etc to an electrical outlet.
• Form customized letters or words by hiding the lights between each letter making your
  lettering and/or words easier to read. 

• When making wireforms and have more lights on a side than you need.
• Need to transition to a new place on the light strand and you want to be able to use the same strand without seeing the in-between lights.
• Use for Holidays, Patio Décor, Umbrellas, Weddings or any type of gathering, and
  much more!! It is only limited by your imagination.

These are only a few suggestions for applications of the “No Glow Cap”. If you have an application that is not listed above for the “No Glow Cap”, we would love to hear from you. Please click on the “Contact Us” link at the top of the webpage and write us an e-mail about how you are using the “No Glow Cap” and even attach a picture to share. We always welcome your comments and/or suggestions!!!

INSTALLATION INSTRUCTIONS

1)  Unplug the light strand from the electrical outlet.

2)  Let the lights on the light strand cool down to room temperature before touching any of the bulbs.

3)  Grasp the plastic base of the light bulb socket.

4)  Slide / Push the "No Glow Cap" over the existing light bulb until it is fully seated.

5)  Repeat steps 3 and 4 for all of the other lights that you do not want to see.

6)  Plug the light strand back into the electrical outlet. 

7)  If light is still visible on the bottom of the "No Glow Cap", press the "No Glow Cap" down further until the light disappears. 

REMOVAL INSTRUCTIONS

1)  Unplug the light strand from the electrical outlet.

2)  Let the lights and "No Glow Caps" on the light strand cool down to room temperature before touching any of the bulbs or caps.

3)  Grasp the plastic base of the light bulb socket that has the "No Glow Cap" installed on it.

4)  Pull the "No Glow Cap" off the existing light bulb until it is removed.  Sometimes a twisting action might be needed while pulling on the "No Glow Cap".  If excessive force was used when installing the "No Glow Cap" it may be difficult to remove the cap. 

5)  Repeat steps 3 and 4 for all of the other lights that you do not want to see.

6)  If desired, plug the light strand back into the electrical outlet. 

 No Glow Plugs, LLC is not responsible for any damage that may occur to your light strands, any type of failure and/or electrical wiring due to the use this product.  

SAFETY INSTRUCTIONS AND WARNINGS

The manufacturer and distributor warrant this product only for material and workmanship, and they shall not be liable for any special, incidental or consequential damages or for any damage or loss caused by improper use or installation.

Contact with electricity can cause serious injury or death. Unplug the light strand from the electrical outlet before installing the product.

Use this product only on light strands with fuse overload protection.

Read and follow the light strand “Safety Instructions and Warnings” manual before using this product.

This product may become hot during operation. Make sure to let the lamp and/or “NO Glow Cap” cool down to room temperature before trying to remove from the light strand socket.  Also, make sure to let the lights cool down to room temperature before grasping them to install the "No Glow Cap".